05.02.2012 Sunday

Turning Milling Threading Parting,Grooving Drilling Brazing Carbide Tips Drawing Dies&Nibs Hard Metal Rods All 5 results10 results25 results50 results100 results Tools & Inserts for Parting, Grooving   Tools (Index) Inserts (Index) ISO Designation System Grades Overview Geometries Grades Overview   Grade ISO Group of materials Application LC232F HC-P30                   HC-M25                   LC242W HC-P40                 HC-M30                 LC442W HC-P40                   HC-M40                   LW612 HW-P40             LCM02 CM-P05                   CM-K05                 LDP091 DP-K01                   Standard grade Coated Grades LC232F(HC-P30, HC-M25) Main grade for the groove-turning of steel materials and easy machinable stainless steels with a medium cutting speed, also by interrupted cut. This grade for different areas has a high wear resistance and excellent toughness characteristic in a wide application spectrum.    [top] LC242W(HC-P40, HC-M30) Universal grade for parting and grooving. Tough grade for turning in the middle to coarse cutting of steel and cast steel, austenitic materials with high resistance against deformation with a good wear resistance.    [top] LC442W(HC-M40) Very tough coated carbide grade for parting and groo­ving, especially stainless steels with medium to low cut­ting speeds with unfavourable cutting conditions.    [top] Uncoated Grades LW612 (HW-KIO) Ideal carbide grade for machining of materials with short chips, f.e. aluminium, braze, etc..    [top] Ceramics LCMO2 (CM-P05, CM-K05) Ceramic (mixed-ceramic) for the finishing of cast and very hard steels.    [top] PCD LDPO9I (DP-KOI) PCD-grade for the machining of aluminium, especially aluminium alloys with high content of silicon.    [top]